How to use a pneumatic cylinder | Arduino tutorial - YouTube Crazy Russian Haunter

Hey everyone! If this video went a little fast, and you would like a BEGINNER ARDUINO TUTORIAL. check this video out; https://www.youtube.com/watch?v=vS2-l... . In this video, the basics of Arduino are explained IN DEPTH. So check it out, if you would like to broaden your knowledge. PARTS: Cylinder (Recommended): https://amzn.to/2NG5Qna Tubing: https://amzn.to/2NJtIWO Tube connectors: https://amzn.to/2CfAz8p 1/4" female to 1/8" male (for air compressor fitting): https://amzn.to/2NH5Jb0 Air compressor intake fittings: https://amzn.to/2yluNzc OPTIONAL Air dispursers: https://amzn.to/2J1MdW1 OPTIONAL speed controller (Airflow adjuster): https://amzn.to/2pTAiRl Solenoid: https://amzn.to/2CidK4a Air compressor (I use and like): https://amzn.to/2CNW2q6 Arduino: https://amzn.to/2xCHm8V 9V battery connector for Arduino: https://amzn.to/2RNycyY (Optional) Wired power for Arduino: https://amzn.to/2pUpZMQ Wiring for Arduino: https://amzn.to/2xApX0y Motion sensor: https://amzn.to/2Cfr4pM plumbers tape: https://amzn.to/2CjoAqe Power adaptor with connections: https://amzn.to/2IUh5r8 ___________CODE____________ int sol = 8; //Tell the Arduino that the positive end of the solenoid is //plugged into pin 8 int sen = 1; //Tell the Arduino that the positive end of the Sensor is //plugged into pin 1 void setup() { //this is included in every code we will be //dealing with. This part runs once. pinMode(sol, OUTPUT); //These two lines tell the Arduino if the pinMode(sen, INPUT); // connections are INPUTS or OUTPUTS } void loop() { // this will run continuously after the Void setup has // run once int val = digitalRead(sen); // Instate a new variable, that is reading // whether the sensor is sensing //movement or not. (High or Low) if(val == HIGH){ //If statutes ask the Arduino if the //sensor value is reading HIGH (movement) digitalWrite(sol, HIGH); // if it is high we will send power // to the solenoid delay(1000); }else{ // if it is high we will send power // to the solenoid digitalWrite(sol, LOW); delay(1000); } }

How to use a pneumatic cylinder | Arduino tutorial - YouTube
3,341 Likes	3,341 Dislikes
375,550 views views	4,879 followers
Entertainment	Upload TimePublished on 26 Feb 2017